Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
Rear Axle Hub, Bearing, Cup, and/or Seal Replacement
Rear Axle Hub, Bearing, Cup, and/or Seal Replacement
Special Tools
*
J 2222-C - Wheel Bearing Nut Wrench
*
J 8092 - Universal Driver Handle - 3/4 x 10 inch
*
J 24426 - Outer Wheel Bearing Race Installer
*
J 24427 - Inner Wheel Bearing Race Installer
*
J 44419 - Hub Bearing Installer
*
J 44420 - Differential Bearing Installer
For equivalent regional tools, refer to Special Tools (See: Steering and Suspension/Suspension/Tools and Equipment/Rear Suspension).
Removal Procedure
Note:
*
The wheel speed sensor ring is NOT serviced separately. The hub and wheel speed senor ring are serviced as an assembly.
*
The rear axle hub seal must be replaced anytime the rear axle hub assembly is removed from the axle housing.
*
The wheel studs are serviced separately from the rear axle hub.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair) Lifting and
Jacking the Vehicle.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair
) Tire and Wheel Removal and Installation.
Note: In the following service procedure, it is not necessary to remove the brake caliper from the bracket.
