Silverado 2500 4WD V8-6.6L DSL Turbo VIN 2 (2004)
9. Remove the lifting handles.
Installation Procedure
1. Lubricate the converter pump hub OD and the torque converter seal with clean transmission fluid.
2. Install J 46409 Torque Converter Lifting Handles 180 degrees apart into two lugs on the front of the torque converter.
3. Caution:
Avoid personal injury or property damage when removing or installing the torque converter by seeking an assistant to help lift the torque
converter.
Lift the torque converter and place it in the transmission.
4. Spin the torque converter to engage the turbine shaft splines in the torque converter hub, the ground sleeve splines in the stator race and to engage
the drive flats on the converter pump hub with the oil pump drive gear.
5. The torque converter is correctly installed when the distance from the lugs to the mounting face is the same as when measured before removing the
torque converter.
6. Install the J 21366 Converter Holding Strap.
7. Reinstall the transmission into the vehicle.
