Silverado 2500 4WD V8-6.6L DSL Turbo VIN 2 (2004)
8. Remove the internal wiring harness from the transmission.
Installation Procedure
1. Align the tabs (8) on the new wiring harness U-channel with the solenoid retainer slots for solenoids E (3) and D (2) on the control valve assembly.
Install the solenoid retainers (14) for the E (3) and D (4) solenoids.
2. Important:
The internal wiring harness connectors (7), (9)-(13), and (15) should be in the correct position for installation because of their pre-assembled
position in the U-channel.
Attach the internal wiring harness connectors to solenoids A through F and to the pressure switch assembly.
^
Connector (13) goes to solenoid (6).
^
Connector (12) goes to solenoid (4).
^
Connector (7) goes to solenoid (5).
^
Connector (10) goes to solenoid (2).
^
Connector (11) goes to solenoid (3).
^
Connector (9) goes to solenoid (1).
^
Connector (15) goes to solenoid (16)
