Silverado 2500 4WD V8-8.1L VIN G (2006)
1. Install the brake caliper bracket (1).
2. Perform the following procedure before installing the brake caliper bracket bolts.
1. Remove all traces of the original adhesive patch.
2. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
3. Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the brake caliper bracket bolts (2).
^
Tighten the bolts to 300 Nm (221 ft. lbs.).
4. Install the anti-rattle clips to the brake caliper bracket.
5. Install the brake pads.
6. Slide the brake pads in until they contact the rotor.
7. Install the brake caliper bolts.
^
Tighten the bolts to 108 Nm (80 ft. lbs.).
8. Install the tire and wheel assembly.
9. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
10. Slowly release the brake pedal.
11. Wait 15 seconds, then repeat steps 10-11 until a firm pedal is obtained. This will properly seat the caliper pistons and pads.
12. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary.
Brake Caliper Bracket Replacement - Rear
Brake Caliper Bracket Replacement - Rear
