Silverado 2500 4WD V8-8.1L VIN G (2006)
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the generator bolts.
Tighten the bolts to 50 N.m (37 lb ft).
3. Install the drive belt.
4. Install the generator cable to the generator, perform the following:
1. Install the generator cable.
2. Install the generator cable nut to the terminal.
Tighten the nut to 9 N.m (80 lb in).
3. Slide the boot over the terminal stud.
5. Connect the generator electrical connector (1).
6. Connect the negative battery cable.