Silverado 2500 4WD V8-8.1L VIN G (2006)
2. Align the tab on the fill tube plug (1) with the tang on the main housing.
3. Install the fill tube plug (1). Press the plug into the seal (2) until the tab on the fill tube plug locks into place in the notch on the main housing.
4. Install a NEW fill tube seal.
5. Install the fill tube. Ensure that the fill tube bracket is positioned properly on the studs.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the fill tube nuts.
^
Tighten the nuts to 18 Nm (13 ft. lbs.).
7. Lower the vehicle.
8. Fill the transmission to the proper level with approved fluid.
Manual Shift Shaft Seal Replacement
Manual Shift Shaft Seal Replacement
^
Tools Required
-
J 43911 Manual Shift Shaft Seal Remover
-
J 43909 Manual Shift Shaft Seal Installer
Removal Procedure
1. Be sure that the jackscrew for J 43911 is backed off and will not interfere with installation of the removal tool. Slide the seal remover tool over the
manual shift shaft (2) with the threaded end of the tool towards the seal.
2. Rotate the removal tool so that the threads on the end of the tool engage the steel shell (1) of the seal. Use a wrench to be sure that the removal tool
is firmly attached to the seal shell.
3. Rotate the jackscrew in the clockwise direction to remove the seal from the bore. Discard the seal that was removed.
Installation Procedure
