Silverado 2500 4WD V8-8.1L VIN G (2006)
Shifter M/T: Service and Repair
ZF S6-650 - Manual Transmission
Shift Lever Assembly Replacement
Removal Procedure
Important:
^
Ensure that the control lever is positioned into the mechanical third or fourth gear prior to removal of the shift lever assembly from the
transmission. The transmission must remain in this state when the shift lever assembly is removed.
^
When removing the shift lever assembly from the transmission, use the exposed bolts on the base of the shift lever assembly.
1. Remove the control lever and boot.
2. With a flat-bladed tool, pull back the insulator between the body and transmission to access the shift tower bolts.
3. Remove the boot.
4. Remove the shift lever bolts.
5. Remove the shift lever and seal.
6. Remove the shift lever insulator.
Installation Procedure
