Silverado 3500 2WD V8-6.0L (2007)
Notice: Refer to Fastener Notice.
4. Install the valve lifter guide bolts (211).
Tighten the bolt to 12 N.m (106 lb in).
5. Install the cylinder head and gasket.
Valve Lifter Replacement (L92 - Second Design)
Valve Lifter Replacement (L92 - Second Design)
Removal Procedure
1. Remove the cylinder head and gasket.
2. Remove the valve lifter guide bolts (211).
3. Remove the valve lifter guides (210) with the lifters. Note the installed position of the guides. The notched area of the guides is to align with the
locating tab on the engine block.
4. Remove the valve lifters (209) from the guide (210).
5. Organize or mark the components so that they can be installed in the same location from which they were removed, if required.
6. Clean and inspect the valve lifters, if required. Refer to Valve Lifters and Guides Cleaning and Inspection (RPO LY2/LY6/L92) Valve Lifters and
Guides Cleaning and Inspection (RPO LH6/LMG/LY5/LC9/L76).
Installation Procedure
