Silverado 3500 2WD V8-6.0L (2007)
Rear Engine Plate: Service and Repair
Engine Rear Cover Replacement
Tools Required
j 41476 Front and Rear Cover Alignment Tool
Removal Procedure
1. Remove the automatic transmission flexplate.
2. Remove the oil pan-to-rear oil seal housing bolts (1).
3. Remove the rear oil seal housing bolts (517).
4. Remove the rear oil seal housing (518) and gasket (519). Discard the gasket.
5. Remove and discard the rear oil seal (141).
Installation Procedure
Important:
*
Do not reuse the crankshaft oil seal or rear cover gasket.
*
Do not apply any type of sealant to the rear cover gasket, unless specified.
*
The special tool in this procedure is used to properly center the crankshaft rear oil seal.
*
The crankshaft rear oil seal will be installed after the rear cover has been installed and aligned. Install the rear cover without the
crankshaft oil seal.
