Silverado 3500 2WD V8-6.0L (2007)
1. Remove the torque converter from the transmission.
2. Obtain J 24171-A and install the tip (3) with a 90 degree hook onto the end of the slide-hammer (1).
3. Position the 90 degree hook behind the rear face of the seal outer case (2). Remove the torque converter seal using the slide-hammer.
4. Inspect the seal bore for scratches. Remove any scratches in the seal bore using crocus cloth.
Installation Procedure
1. Install the new seal (2) onto the J 43772. Position the seal so the seal lip is outward and the face of the steel case is against the driving face (1) on
the tool.
2. Slide J 43772 over the turbine shaft and the stator shaft until the seal starts into the seal bore. Strike the J 43772 with a mallet (1) to drive the seal
into the seal bore. The seal is installed correctly when the shoulder of the J 43772 squarely contacts the outer surface of the oil pump.
3. Install the torque converter into the transmission.
Torque Converter Housing Bolt Seal Replacement
Torque Converter Housing Bolt Seal Replacement
Removal Procedure
