Silverado 3500 2WD V8-6.0L VIN U (2004)
1. Lubricate a NEW O-ring seal with transmission fluid.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the VSS and bolt.
^
Tighten the bolt to 10 Nm (89 inch lbs.).
3. If equipped with the 8.1L engine, connect the VSS electrical connector (5).
4. If equipped with the 6.6L engine, connect the VSS electrical connector (4).
5. Lower the vehicle.
6. Check the transmission fluid level. Add if necessary.
