Silverado 3500 2WD V8-6.0L VIN U (2004)
8. Install two M11x1.5 mm bolts (1) to the threaded holes of the spacer, if applicable.
9. Rotate the bolts clockwise to remove the spacer.
10. Remove the spacer from the rear of the crankshaft, if applicable.
Installation Procedure
Important:
^
The flywheel does not use a locating pin for alignment and will not initially seat against the crankshaft flange or spacer (if applicable), but will be
pulled onto the crankshaft by the engine flywheel bolts. This procedure requires a three stage tightening process.
^
Certain applications (4.8 L manual transmissions or all 6.0 L) require a spacer and longer bolts for proper flywheel position.
