Silverado 3500 2WD V8-6.6L DSL Turbo (2006)
1. Install the fuel pressure sensor (3).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the sensor to 70 N.m (52 lb ft).
2. Connect the fuel rail pressure sensor electrical connector (4).
3. Install the EGR cooler heat protector (2) and bolt (1).
Tighten the bolt to 25 N.m (18 lb ft).
4. Install the EGR cooler tube.
5. Install the air cleaner outlet duct.
6. Prime the fuel system. Refer to Fuel System Priming.
7. Start the engine. If the engine stalls, repeat the above step.
8. Once the engine starts, inspect for fuel leaks.
