Silverado 3500 2WD V8-6.6L DSL Turbo (2006)
Fuel Return Line: Service and Repair
Fuel Feed and Fuel Return Pipe Purge Procedure
FUEL FEED AND FUEL RETURN PIPE PURGE PROCEDURE
1. Pump the primer located on top of the fuel filter 30 times or until stiff.
2. Attempt to start and run the engine. If the engine does not start, repeat step 1.
3. Allow to run for 5 minutes at idle.
4. Check for fuel leaks.
5. Clear all engine diagnostic trouble codes (DTCs).
Fuel Hose Replacement - Fuel Filter/Heater Element Housing to Fuel Feed Block
FUEL HOSE REPLACEMENT - FUEL FILTER/HEATER ELEMENT HOUSING TO FUEL FEED BLOCK
REMOVAL PROCEDURE
1. Reposition the hose clamps at the fuel filter and the return line.
2. Remove the fuel hose (1) from the fuel filter housing and the return line.
INSTALLATION PROCEDURE