Silverado 3500 2WD V8-6.6L DSL Turbo (2006)
^
Dry or brittle
^
Compression set
Installation Procedure
1. Clean all corrosion or contaminates from the steering knuckle bore and the hub and bearing.
2. Lubricate the steering knuckle bore with wheel bearing grease or the equivalent.
3. Install the O-ring (7) to the steering knuckle, 25/35 series.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
4. Install the wheel speed sensor mounting bolt.
Tighten
Tighten the bolt to 18 N.m (13 lb ft).
5. Install the wheel hub and bearing and splash shield to the vehicle, 25/35 series.
