Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
Hood Latch: Service and Repair
Hood Link Replacement
Hood Link Replacement
Removal Procedure
Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the
vehicle or personal injury.
1. Raise and support the front of the hood (1).
2. Remove the bolts (7) holding the hood link assembly to the hood hinge.
3. Remove the bolts (5) holding the hood link assembly to the fender.
4. Remove the hood link assembly from the vehicle.
Installation Procedure
1. Position the hood link assembly (6) to the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the bolt (5) holding the hood link assembly to the fender.
Tighten the link assembly to the fender bolt to 25 N.m (18 lb ft).
3. Install the fender bolt (7) holding the hood link assembly to the hood hinge.
Tighten the hinge bolts to 25 N.m (18 lb ft).
