Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
1. Remove the rear seat from the vehicle.
2. Remove the rear passenger seat riser.
3. Remove the hog rings and/or the J-clips from the rear edge of the seat cushion cover (3).
4. Disconnect the rear heater connector, if equipped.
5. Remove the seat belt buckles, if required.
6. Remove all of the remaining hog rings, and/or the J-clips that are retaining the seat cushion cover (3) to the seat cushion frame (8).
7. Release the hook, and the loop-strips that are retaining the seat cushion cover to the foam pad (4).
8. Remove the center screw retaining the latch cover, if equipped.
9. Remove the seat cushion cover from the foam pad.
INSTALLATION PROCEDURE
