Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
6. If the brake rotor assembled LRO measurement exceeds the specification, bring the LRO to within specifications. Refer to Brake Rotor Assembled
Lateral Runout (LRO) Correction.
7. Install the rotor by slowly turning the rotor while pushing the rotor towards the axle.
8. Install the caliper and the bracket as an assembly to the vehicle.
9. Perform the following procedure before installing the caliper bracket mounting bolts.
1. Remove all traces of the original adhesive patch.
2. Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.
3. Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
10. Notice:
Refer to Fastener Notice in Service Precautions.
Install the caliper bracket mounting bolts.
For the 15 series, tighten the brake caliper bracket mounting bolts to 200 Nm (148 ft. lbs.).
For the 25/35 series, tighten the brake caliper bracket mounting bolts to 165 Nm (122 ft. lbs.).
11. Install the tire and wheel assembly.
12. Lower the vehicle.
13. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
14. Slowly release the brake pedal.
15. Wait 15 seconds, then repeat steps 13-14 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
16. Fill the master cylinder reservoir to the proper level with clean brake fluid. Refer to Master Cylinder Reservoir Filling in Hydraulic Brakes.
(W/Dual Wheels)
Brake Rotor Replacement - Rear (W/Dual Wheels)
Caution: Refer to Brake Dust Caution in Service Precautions.