Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer Vehicle Lifting
3. Remove the tire and wheel assembly.
4. Remove the hub and rotor assembly.
5. Mark the relationship of the hub to the rotor.
6. Place the hub and rotor assembly on a hydraulic press.
7. Press the wheel studs out of the hub and rotor assembly.
Installation Procedure
1. Align the hub and the rotor (if applicable).
2. Install each of the new wheel studs into the hub and rotor assembly by performing the following steps:
1. Install the stud.
2. Install 4 washers to the stud.
3. Install a lug nut to the stud with the flat side of the nut towards the washers.
4. Tighten the lug nut to draw the stud into the hub and rotor assembly.
5. Inspect the hub and rotor assembly to ensure that the hub is tight against the rotor and the stud is seated completely.
6. Remove the lug nut and the washers.
3. Install the hub and rotor assembly to the vehicle.
4. Install the tire and wheel assembly.
5. Lower the vehicle.
6. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
7. Slowly release the brake pedal.
8. Wait 15 seconds, then repeat steps 6-7 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
9. Fill the master cylinder reservoir to the proper level with clean brake fluid. Refer to Master Cylinder Reservoir Filling in Hydraulic Brakes.
