Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
(W/NYS)
Brake Rotor Replacement - Rear (W/NYS)
^
Tools Required
-
J 41013 Rotor Resurfacing Kit
-
J 42450-A Wheel Hub Resurfacing Kit
Caution: Refer to Brake Dust Caution in Service Precautions.
Removal Procedure
1. Release the park brake.
2. Raise and suitably support the vehicle. Refer Vehicle Lifting
3. Remove the tire and wheel assembly.
4. Mark the relationship of the rotor to the hub.
5. Install a C-clamp over the body of the brake caliper, with the C-clamp ends against the rear of the caliper body and the outboard disc brake pad.
6. Slowly tighten the C-clamp until the pistons are pushed into the caliper bores enough to remove the caliper from the pads.
7. Remove the C-clamp from the caliper.
8. Remove the nut and the bolt from the quarter shaft shield.
9. Remove the shield.
