Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
8. Disconnect the 2 way ABS pump motor connector.
9. Remove the bolts (1) from the EBCM (2).
10. Notice: Do not use a tool to pry the EBCM or the BPMV. Excessive force will damage the EBCM.
Important:
Do not reuse the EBCM mounting bolts. Always install new bolts.
Remove the EBCM (2) from the BPMV (3). Removal may require a light amount of force.
11. Clean the EBCM to BPMV mounting surfaces with a clean cloth.
Installation Procedure
1. Important:
Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
Install the EBCM (2) onto BPMV (3).
2. Important:
Do not reuse the old mounting bolts. Always install new bolts with the new BPMV.
Install the four EBCM bolts.
^
Tighten the four bolts to 5 Nm (39 inch lbs.) in an X-pattern.
3. Connect the 2 way ABS pump motor connector to the EBCM.
4. Install the BPMV (3) to BPMV bracket (5).
5. Install the BPMV to bracket retaining bolts (4).
^
Tighten the bolts to 9 Nm (7 ft. lbs.).
6. Install the EHCU assembly (1, 2) to the vehicle frame (5).
