Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
2. Align the slots in both the adjusting screw (1) and tappet to be parallel with the backing plate face.
3. Install the park brake shoe assembly to the vehicle by placing one of the open ends of the shoe (2) over the axle flange and rotating the shoe until it
is behind the flange.
4. Position the park brake shoe (2) on the inboard side of the actuator.
5. Slide the park brake shoe (2) into position and seat into the retaining spring (3).
6. Inspect the shoe assembly position. The shoe must be central on the backing plate with both tips located in the slots.
7. Adjust the park brake shoe. Refer to Park Brake Adjustment See: Adjustments.
8. Install the rotor. Refer to Rear Brake Rotor Replacement in Disc Brakes See: Disc Brake System/Brake Rotor/Disc/Service and Repair.
9. Install the park brake cable to the park brake actuator lever.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
10. Tighten the nut to the intermediate cable at the equalizer.
Tighten
Tighten the nut to 3.5 Nm (31 lb in).
11. Install the tire and wheel.
12. Remove the safety stands.
13. Lower the vehicle.
14. Adjust park brake cable. Refer to Park Brake Adjustment See: Adjustments.
