Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
Parking Brake Shoe: Service and Repair
Parking Brake Shoe Replacement (RPO NYS)
Parking Brake Shoe Replacement (RPO NYS)
Removal Procedure
Caution: Avoid taking the following actions when you service wheel brake parts:
-
Do not grind brake linings.
-
Do not sand brake linings.
-
Do not clean wheel brake parts with a dry brush or with compressed air.
Some models or aftermarket brake parts may contain asbestos fibers which can become airborne in dust. Breathing dust with asbestos fibers may cause
serious bodily harm. Use a water-dampened cloth in order to remove any dust on brake parts. Equipment is available commercially in order to perform
this washing function. These wet methods prevent fibers from becoming airborne.
1. Release the park brake.
2. Raise and support the vehicle.
3. Remove the tire and wheel assembly.
4. Relieve the tension from the park brake cable by pulling down on the intermediate cable then release the cable from the equalizer bar.
5. Remove the rear park brake bracket bolt.
