Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
45.
Perform the following procedure to remove the cable (2) from the backing plate (4):
45.1 Compress the spring (3) by pushing towards the lever (1).
45.2 Depress the locking tabs.
45.3 Pull the cable housing out of the backing plate (4).
45.4 Remove the cable (2) through the slot in the backing plate.
46.
Remove the park brake cable (2) from the lever (1).
47.
Remove the cable from the vehicle.
48.
Install the new cable to the vehicle.
49.
Install the park brake cable (2) to the lever (1).
50.
Perform the following procedure to install the cable (2) to the backing plate (4):
50.1 Compress the spring (3) by pushing towards the lever (1).
50.2 Route the cable (2) through the slot in the backing plate.
50.3 Push the cable housing into the backing plate (4) until the locking tabs snap into place.
51.
Bolt the cable to the differential clips.
Tighten
Tighten the bolt to 25 N.m (18 lb ft).
Important:
After installing the cable to the rear axle holding clip, verify that the clip is securely retaining the cable. If not, crimp the clip by hand, taking
care not to pinch or kink the cable.
52.
Install the cable to the differential clip.
53.
Connect the cable at the equalizer.
54.
Install the wheels and tires.
55.
Hold the park brake pedal in the FULL upward position.
