Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
56.
Pull rearward on the front park brake cable until the tension is released from the scribe or nail (1) installed through the holes in the pedal assembly.
57.
Remove the scribe or screwdriver (1).
58.
Slowly release the park brake cable until it returns to its original position.
59.
Release the park brake pedal.
Note:
A torque wrench or J 39544 must be used to ensure that wheel nuts are tightened to specification. Never use lubricants or penetrating fluids on
wheel studs, nuts, or mounting surfaces, as this can raise the actual torque on the nut without a corresponding torque reading on the torque
wrench. Wheel nuts, studs, and mounting surfaces must be clean and dry. Failure to follow these instructions could result in wheel, nut, and/or
stud damage.
60.
Install the tire and wheel.
61.
Install the wheel nuts.
Tighten
Tighten the wheel nuts as shown to 190 N.m (140 lb ft).
62.
Install the wheel center cap.
63.
Lower the vehicle.
64.
Apply and release the park brake pedal to ensure that there is no binding or sticking.
