Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
7. Reposition the inlet heater hose clamp (4) from the auxiliary water pump (1).
8. Remove the inlet heater hose (6) from the auxiliary water pump (1).
INSTALLATION PROCEDURE
1. Install the inlet heater hose (6) to the auxiliary water pump (1).
2. Position the inlet heater hose clamp (4) to the auxiliary water pump (1).
3. Install the inlet heater hose to the engine.
4. Position the inlet heater hose clamp to the engine.
IMPORTANT: Align the arrow at the throttle body end of the duct with the throttle body attaching stud.
