Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
15. Discard all of the used sealing washers. Cap all of the open connections.
INSTALLATION PROCEDURE
1. Install the front evaporator tube to the vehicle.
2. Uncap all of the open connections
3. Install the evaporator tube to the condenser using new sealing washers.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the evaporator tube nut to the condenser.
Tighten
Tighten the nut to 16 N.m (12 lb ft).
5. Install the grille to the vehicle.
6. Install the right park/turn signal lamp.
