Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
supported, only J2534.
1. BEFORE the original IPC is disconnected from the vehicle, record the odometer and engine hour values.
2. Replace the IPC with a replacement part obtained from the ESC. Refer to Instrument Cluster Replacement in SI.
3. Using the TIS2WEB SPS application, select either: J2534 Tech 2 or J2534 MDI, when available and build the vehicle.
4. Select: IPC Setup J2534.
5. After selecting IPC Setup J2534, the user will be prompted to: install the new controller. Ignore this prompt if the new IPC was already installed.
This prompt is just to remind the user that this application is only for a new IPC.
Important
FOR 2003 FULLSIZE TRUCKS, UTILITIES AND H2, THE ENGINE MUST BE STARTED AND RUNNING PRIOR TO ENTERING
THE MILEAGE AND ENGINE HOURS. After the odometer value is programmed, the engine must remain running for 6 minutes 15
seconds before the ignition can be turned off. Failure to do so will result in engine hours not being programmed and a new IPC will have
to be ordered.
6. Enter the odometer and engine hour values, when applicable. By default the application will be set to miles. For metric units, click the button on
the left next to: Kilometers. The IPC odometer and engine hour meter setup procedure is now complete.
7. The IPC calibration files can now be programmed into the IPC. Refer to SPS in SI.
Disclaimer
