Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
28. Remove the tape from the turbocharger openings.
IMPORTANT: Lubricate the end of the duct prior to installation.
29. Install the charged air cooler inlet duct connector (4) to the turbocharger.
30. Tighten the charged air cooler inlet duct to turbocharger clamp (1).
Tighten
Tighten the clamp to 6 N.m (53 lb in).
31. Position the junction block and bracket.
32. Install the battery cable junction block bracket bolt (1) to the power steering pump bracket.
Tighten
Tighten the bolt to 9 N.m (80 lb in).
33. Install the water outlet tube.
34. Connect the negative battery cable.
35. Prime the fuel system. Refer to Fuel System Priming.
36. Start the engine. If the engine stalls, repeat the above step.
37. Once the engine starts, inspect for fuel leaks.
