Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
2. Install the return/junction block bolt (1).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the return/junction block line clamp bolt (2).
Tighten
Tighten the bolts to 25 N.m (18 lb ft).
4. Install the return/junction block hoses.
5. Position the return/junction block hose clamps (3).
6. Connect the right fuel return line to the return/junction block line.
7. Install the hose (1) to the return/junction block.
8. Position the fuel hose clamp at the return/junction block.
9. Prime the fuel system. Refer to Fuel System Priming.
10. Start the engine. If the engine stalls, repeat the above step.
11. Once the engine starts, inspect for fuel leaks.
