Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
16. Connect the fuel lines.
17. Position the generator positive cable.
18. Install the generator positive cable in the clip on the engine front cover.
19. Install the generator positive cable and nut to the generator.
Tighten
Tighten the nut to 9 N.m (80 lb in).
20. Install the battery positive cable junction block bracket and bolt (1) to the power steering bracket.
Tighten
Tighten the bolt to 9 N.m (80 lb in).
21. Remove the tape from the turbocharger openings.
IMPORTANT: Lubricate the end of the duct prior to installation.
22. Install the charged air cooler inlet duct connector (4) to the turbocharger.
23. Tighten the charged air cooler inlet duct connector to turbocharger clamp (1).
Tighten
Tighten the clamp to 6 N.m (53 lb in).
24. Install the intake manifold cover.
25. Fill the cooling system.
26. Connect the negative battery cable.
27. Prime the fuel system. Refer to Fuel System Priming.
28. Start the engine. If the engine stalls, repeat the above step.
29. Once the engine starts, inspect for fuel leaks.
