Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
1. Install the fuel temperature sensor.
Tighten
Tighten the sensor to 22 N.m (16 lb ft).
2. Connect the fuel temperature sensor electrical connector.
3. Remove the tape from the turbocharger openings.
4. Install the charged air cooler inlet duct connector (4) to the turbocharger.
5. Tighten the charged air cooler inlet duct connector to turbocharger clamp (1).
Tighten
Tighten the clamp to 6 N.m (53 lb in).
6. Install the intake manifold cover.
7. Prime the fuel system. Refer to Fuel System Priming.
8. Start the engine. If the engine stalls, repeat the above step.
9. Once the engine starts, inspect for fuel leaks.
