Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
Transmission Position Switch/Sensor: Adjustments
Automatic Transmission - Allison
Park/Neutral Position Switch Adjustment
^
Tools Required
-
J 41364-A PNP Switch Adjusting Tool
Caution: Refer to Battery Disconnect Caution in Service Precautions.
1. Make sure the selector shaft is in the N (Neutral) position as follows:
^
Place a wrench on the selector shaft flats and rotate the shaft to its furthest clockwise position.
^
Rotate the selector shaft counter-clockwise two detents.
2. Be sure that J 41364-A (2) is in the proper position on PNP switch (1).
3. While maintaining the correct PNP switch-to-selector-shaft alignment, slide the new PNP switch (5) over the selector shaft (4).
4. Notice:
Refer to Component Fastener Tightening Notice in Service Precautions.
