Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
Maintain the sensor position. Do not turn the sensor.
Remove the rear wheel position sensor (2) from the steering gear.
Installation Procedure
1. Important:
Make sure the O-ring (1) is installed.
Install the rear wheel position sensor (2) to the steering gear.
2. Important:
Be careful to maintain the position of the replacement sensor.
Remove the pin retaining the position of the new sensor and immediately install the sensor to the steering gear.
3. Notice:
Refer to Fastener Notice in Service Precautions.
Install the rear wheel position sensor retaining bolts. Apply LOCTITE 242 blue.
^
Tighten the bolts to 4 Nm (35 inch lbs.).
4. Install the rear wheel position sensor cover (4).
5. Connect the electrical connector (1).
6. Install the steering gear protection shield (1) and retaining bolts (3).
^
Tighten the steering gear protection shield retaining bolts to 180 Nm (132 ft. lbs.).
