Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
2. Connect the power steering inlet hose to the power steering pump (5).Install the retaining clamp.
3. Connect the power steering outlet hose (4) to the power steering gear (3).Install the retaining clamp.
4. Bleed the power steering system. Refer to Bleeding the Power Steering System.
5. Inspect all the hose connections for leaks.
6. Install the front grille. Refer to Grille Replacement (GMC) Grille Replacement (Chevrolet) in Exterior Trim.
(With Hydroboost)
Power Steering Cooler Pipe/Hose Replacement (With Hydroboost)
Removal Procedure
1. Remove the front grille. Refer to Grille Replacement (GMC) Grille Replacement (Chevrolet) in Exterior Trim.
2. Notice:
Refer to Power Steering Hose Disconnected Notice in Service Precautions.
Place a drain pan under the vehicle.
3. Siphon the fluid from the reservoir to prevent excess spillage.
4. Remove the clamp retaining the power steering cooler inlet hose (3) to the power steering gear (2).
5. Remove the clamp retaining power steering cooler outlet hose (5) to the power steering pump (1).
6. Remove the bolts (2) retaining the power steering cooler from the radiator support.
7. Remove the power steering cooler from the vehicle.
Installation Procedure
