Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
1. Notice:
Refer to Fastener Notice in Service Precautions.
Place the new pressure switch manifold assembly (2) in position and install one bolt (1) in a recessed location to hold it into position. Start the
remaining four bolts (1) in recessed locations and tighten the bolts by hand.
Torque the bolts to 12 Nm (108 inch lbs.).
2. Connect the internal wiring harness connector to the pressure switch assembly.
3. Install the reverse signal tube (1). Install two bolts (2).
^
Tighten the bolts to 12 Nm (108 inch lbs.).
4. Install the oil pan and suction filter.
