Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
1. Lubricate the input speed sensor seal with automatic transmission fluid.
2. Install the input speed sensor (1).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the input speed sensor bolt.
^
Tighten the bolt to 11 Nm (96 inch lbs.).
4. Connect the input speed sensor electrical connector (1).
5. Lower the vehicle.
Output Shaft Speed Sensor Replacement
Output Shaft Speed Sensor Replacement
Removal Procedure
Important: This procedure is for 2-wheel drive (2WD) vehicles only. If the vehicle is equipped with 4-wheel drive (4WD), the output speed sensor
is located on the transfer case.
