Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
7. Install the detent spring assembly (2) onto the control valve assembly. Confirm that the roller of the detent spring assembly rests on the detent
lever (1).
8. Notice:
Refer to Fastener Notice in Service Precautions.
Install 2 detent spring bolts (3).
^
Tighten the bolts to 12 Nm (108 inch lbs.).
9. Install the oil pan and suction filter.
10. Connect the external wiring harness to the main transmission connector.
Control Valve Body Disassemble
Control Valve Body Disassemble
^
Tools Required
-
J 33163 Valve Tray Set
NOTICE:
^
Transmission damage may occur when control valve assembly springs and other parts are mistakenly interchanged. Interchanging parts can be
avoided by observing the following precautions:
^
Tag each part as it is removed.
^
Use J 33163 Valve Tray Set to organize parts and to simplify correct valve body reassembly.
^
Protect control valve assembly parts from damage by observing the following precautions:
^
Handle all valves carefully.
^
Protect control valve assembly parts during removal, cleaning, inspection, and reassembly.
^
Keep the parts in a clean container until the parts are installed.
^
When a valve is installed dry, the weight of the valve is sufficient to move the valve through the valve bore. If a valve does not move freely, the
transmission may be damaged .
