Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
Pilot Bearing: Service and Repair
Pilot Bearing Replacement
^
Tools Required
-
J 43276 Clutch Pilot Bearing Remover
-
J 38836 Bushing Installer/Clutch Arbor
Removal Procedure
Notice: When using the J 43276 Clutch Pilot Bearing Remover, always secure the J 43276-1 Clutch Pilot Bearing Remover tool body using a wrench.
Do not allow the J 43276-1 tool body to rotate. Failing to do so causes damage to the J 43276-1 tool body.
Important: The flywheel spacer (if applicable) must be removed prior to clutch pilot bearing removal.
1. Remove the clutch assembly.
2. Using J 43276 perform the following in order to remove the clutch pilot bearing:
1. Install the J 43276-1 into the clutch pilot bearing.
2. Using a wrench, secure the J 43276-1.
3. Insert the J 43276-2 into the J 43276-1.
4. Rotate the J 43276-2 clockwise into the J 43276-1 until the clutch pilot bearing is completely removed from the crankshaft.
5. Rotate the J 43276-2 counterclockwise to remove the J 43276-2 from the J 43276-1.
6. Remove the J 43276-1 from the tool body.
