Silverado 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
Shifter M/T: Service and Repair
NV 3500
Shift Lever Assembly Replacement
Removal Procedure
Important:
^
Ensure that the control lever is positioned into the mechanical third or fourth gear prior to removal of the shift lever from the transmission. The
transmission must remain in this state when the shift lever is removed.
^
Do not disassemble the transmission shift lever. Internal parts for this shift lever are not available. Opening the shift lever voids the warranty.
^
When removing the shift lever from the transmission, use the exposed bolts on the base of the lever.
1. Remove the control lever and boot.
2. Remove the boot.
3. Remove the shift lever bolts.
4. Remove the shift lever and seal.
5. Remove the shift lever insulator.
Installation Procedure
1. Install a NEW shift lever insulator.
2. Install the shift lever seal and lever.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the shift lever bolts.
^
Tighten the bolts to 20 Nm (15 ft. lbs.).
4. Install the boot.
5. Install the control lever and boot.
