Silverado 3500 2WD V8-8.1L VIN G (2005)
5. Compress the brake caliper pistons.
1. Install a large C-clamp over the top of the caliper housing and against the back of the outboard pad.
2. Slowly tighten the C-clamp until the pistons are pushed completely into the caliper bores.
3. Remove the C-clamp from the caliper.
6. Loosen the rear brake caliper mounting bolts. Do not remove.
7. Remove the brake caliper bracket bolts (2).
8. Remove the caliper bracket (1) and brake caliper as an assembly.
9. Notice: Refer to Brake Caliper Notice in Service Precautions.
Remove the caliper bolts from the caliper bracket. Support the caliper with heavy mechanic's wire or equivalent. DO NOT disconnect the
hydraulic brake hose from the caliper.
10. Remove the brake pads from the caliper bracket.
11. Remove the anti-rattle clips.
Installation Procedure
