Silverado 3500 2WD V8-8.1L VIN G (2005)
4. Install the engine front cover gasket into the front cover.
Important: The following method must be used when installing the engine front cover. Failure to follow the instructions will push the sealant out,
which may cause an oil leak.
5. Install the front cover and gasket.
1. Hold the front cover (1) up to the crankshaft (2).
2. Lift the front cover (1) while sliding the cover over the crankshaft (2).
3. Slide the front cover towards the engine block (5) while keeping the cover raised.
4. Lower the cover down over the dowel pin (4), allowing the front cover to rest on the sealant (3).
6. Install the engine front cover bolts.
Notice: Refer to Fastener Notice in Service Precautions.
7. Tighten the engine front cover bolts.
1. Tighten the engine front cover bolts in sequence a first pass to 6 Nm (53 inch lbs.).
2. Tighten the engine front cover bolts in sequence a final pass to 12 Nm (106 inch lbs.).
