Silverado 3500 2WD V8-8.1L VIN G (2005)
1. Install the accelerator pedal assembly.
NOTE: Refer to the Fastener Notice in Service Precautions.
2. Install the accelerator pedal nuts.
Tighten the nuts to 20 N.m (15 lb ft).
3. Reposition the carpet.
4. Connect the APP sensor electrical connector.
5. Install the CPA retainer.
6. Reposition the carpet.
7. Connect a scan tool in order to test for proper throttle-opening and throttle-closing range.
8. Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed
throttle, and a wide open throttle (WOT).
9. Verify that the vehicle meets the following conditions:
-
The vehicle is not in a reduced engine power mode.
-
The ignition is ON.
-
The ignition is OFF.
10. Inspect the carpet fit under the accelerator pedal.
