Silverado 3500 2WD V8-8.1L VIN G (2005)
4. Install a NEW fill tube seal.
5. Install the fill tube. Ensure that the fill tube bracket is positioned properly on the studs.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the fill tube nuts.
^
Tighten the nuts to 18 Nm (13 ft. lbs.).
7. Lower the vehicle.
8. Fill the transmission to the proper level with approved fluid.
Seal Replacement - Torque Converter
Seal Replacement - Torque Converter
^
Tools Required
-
J 24171-A Seal and Dust Shield Remover
-
J 43772 Torque Converter Seal Installer
Removal Procedure
1. Remove the torque converter from the transmission.
2. Obtain J 24171-A and install the tip (3) with a 90 degree hook onto the end of the slide-hammer (1).
3. Position the 90 degree hook behind the rear face of the seal outer case (2). Remove the torque converter seal using the slide-hammer.
3. Inspect the seal bore for scratches. Remove any scratches in the seal bore using crocus cloth.
Installation Procedure
1. Install the new seal (2) onto the J 43772. Position the seal so the seal lip is outward and the face of the steel case is against the driving face (1) on
the tool.
