Silverado 3500 2WD V8-8.1L VIN G (2005)
A/B Solenoid Bracket Inspection
1. Measure the angle between the surfaces of the A/B solenoid bracket (1) (Angle A).
2. Adjust the bracket surfaces until the angle between the surfaces is 82.84 degrees.
Control Valve Body Assemble
Control Valve Body Assemble
^
Tools Required
-
J 33163 Valve Tray Set
-
J 43773 Valve Spring Compressor
Shift Valve Body Assemble
1. Important:
^
Transmission damage may occur when control valve assembly springs and other parts are mistakenly interchanged. Interchanging parts can be
avoided by the following:
^
Tag each part as it is removed.
^
Use J 33163 to organize parts and to simplify correct valve body reassembly.
Protect control valve assembly parts from damage observing the following precautions
^
Handle all valves carefully.
^
Protect control valve assembly parts during removal, cleaning, inspection, and reassembly.
^
Keep parts in a clean container until the parts are installed.
Install solenoid screen (1).
Ensure solenoid screen (1) is installed to a depth of 0.50-1.00 mm (0.20-0.039 inch) (Dimension A) below the shift valve body surface, as shown.
