Silverado 3500 2WD V8-8.1L VIN G (2005)
5. Using J 6125-1B (1) and J 23129 (2), remove the rear oil seal.
Installation Procedure
Important: The J 44732 will set the oil seal to the proper depth. Failure to use the J 44732 will cause improper installation of the oil seal.
1. Using J 44732 install the rear oil seal.
2. Install the yoke.
3. Use the J 8614-01 in order to hold the yoke.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install a NEW yoke nut.
^
Tighten the nut to 330 Nm (244 ft. lbs.).
5. Install the rear propeller shaft.
6. Check the transmission fluid level. Add if necessary.
7. Lower the vehicle.
