Silverado 3500 2WD V8-8.1L VIN G (2005)
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the output speed sensor (2) electrical connector.
3. Remove the output speed sensor bolt.
4. Remove the output speed sensor (2).
5. Inspect the output speed sensor (2) for any evidence of damage.
Installation Procedure
1. Lubricate the output speed sensor seal with automatic transmission fluid.
2. Install the output speed sensor (2).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the output speed sensor bolt.
^
Tighten the bolt to 11 Nm (96 inch lbs.).
