Silverado 3500 4WD V8-6.0L (2007)
Hand start each bolt to ensure that the ring gear is properly installed to the differential case.
Notice: Refer to Fastener Notice.
4. Tighten the new ring gear bolts. Tighten the ring gear bolts alternately and in stages, gradually pulling the ring gear onto the differential case.
Tighten the ring gear bolts in sequence to 165 N.m (122 lb ft).
5. Install the pinion and the pinion bearings.
6. Install the pinion gear bearing retainer.
7. Install the differential assembly.
8. Fill the axle with lubricant. Use the proper fluid. Refer to Rear Axle Lubricant Replacement (8.6 Inch Axle) Rear Axle Lubricant Replacement
(9.5 LD Axle) Rear Axle Lubricant Replacement (9.5 Inch HD and 10.5 Inch Axles).
9. Lower the vehicle.
