Silverado 3500 4WD V8-6.0L VIN U (2004)
12. Pack the CV joint boot (1) and the CV joint assembly with the grease supplied in the kit. The amount of grease supplied in this kit has been
pre-measured for this application.
13. Place the new small boot clamp (2) onto the CV joint seal (1).
14. Slide the CV joint boot (1) onto the halfshaft bar.
15. Position the small end of the CV joint boot (1) into the joint boot groove (3) on the halfshaft bar.
Notice: Refer to Fastener Notice in the Preface.
16. Secure the small boot clamp (1) using J35910 (or equivalent), a breaker bar, and a torque wrench. Tighten the small clamp (1) to 136 Nm (100 lb
ft).
17. Check the gap dimension on the clamp ear. Continue tightening until the gap dimension is reacted.
