Silverado 3500 4WD V8-6.0L VIN U (2004)
9. Disassemble the harness connector (1) from the encoder.
10. Remove the encoder from the output shaft using a flat tip screwdriver.
Installation Procedure
1. Assemble the harness to the NEW encoder with the connector legend "TOP" (1) and the encoder part number facing up.
2. Assemble the output shaft into the encoder, being sure to align the encoder tab with the groove on the shaft.
3. Ensure the encoder is seating properly on the output gear.
4. Place the output shaft encoder on the casting.
5. Place the grommet harness on the casting slot, the flat area on the grommet will be facing up.
